N60 W15088 Bobolink Ave. --  Menomonee Falls, WI 53051 -- (262) 252-3804 / 800-366-1973 - Email Badger Metal Tech

Javascript DHTML Drop Down Menu Powered by dhtml-menu-builder.com

Why do we use Lambda to measure values?
 Curves and Graphs for tool steel
Compressive Stress + Nitrocarburizing = Longer Tool Life
The compressive stress factor of MetaLLifeÒ offers an increase of 30-40% of the effective yield strength of tool steel.  When combined with our TherMaLL ifeÒ  nitrocarburizing process, tooling has then both fatigue and wear resistance. 
TherMaLL ifeÒ  is not recommended for D-2 unless final temper was done at above 1000 degrees F.

The microstructure of a ferritic nitrocarburized H-13 surface shows an epsilon compound layer that is .0002" to .0008" in depth followed by the sub-surface diffusion zone (carbon/nitrogen) ranging in depth from .004" to .008" (dependent on processing criteria) which gradually dissipates.







Coupons with perfect surface finish after combination processing.
Click on coupon to view a section

Coupons with perfect surface finish after combination processing.
Click on coupon to view a section
 

Page was last modified 02/20/2010
Home  |  About Us  |  Services  |  Gallery |  Glossary  |  Contact Us

Copyright © 1996-2009 Badger Metal Tech, Inc. All Rights Reserved.
Reproduction in whole or in part in any form or medium without express written permission of Badger Metal Tech is Prohibited.
 MetaLL ifeÒ and TherMaLLifeÒ are registered with the US patent and trademark office. Intellectual property and graphics contained herein are the sole property of Badger Metal Tech, Inc.